Display Settings

[boro]

Hi, I am running SBS3 version 178. Everything seems to be working ok including SDR's but when I tried to get in to "Display Settings.." a window box appears and goes in less then a second. After two attempts of trying to get the "Display Settings..." window box to appear BS freezes up and I have to go into the task manager to close BS down. I haven't had a reason to use "Display Settings..." for a while so I don't know how long it has been like this. All the other menues under "Settings" work ok. Anyone got any ideas what is causing this? I am running Window 7 using firmware 115.

Cheers

Peter

[Anmer]

Is this happening if you close and re open Basestation?

Can you try renaming the sub-folder in the Basestation directory from OperatorFlags to OperatorFlagsOld.

Then start Basestation again and see if you get the same issue?

[boro]

Thanks for your reply. BS itself opens and closes down ok. I have renamed OperatorFlags to OperatorFlagsOld and I can now open "Display Settings..." and all the tabs in it but I don't have any flags showing in BS now.

[Anmer]

OK, I was trying to determine if there's a bad file in that folder which I suspect there is.

Can you run the BMPCHK file checker to try and identify the culprit?

Then delete the file and rename the folder back to its original name:

http://radarspotting.com/forum/index.php?action=tpmod;dl=item95

[boro]

Ok I will try that.

For infomation I closed BS down and renamed OperatorFlagsOld back to its original name and this time BS would not open so I renamed them back again to OperatorFlagsOld and BS opened up

[boro]

I Run BMPCHK and I had to delete 35 Operator flags but I had to delete all 365 BMPFlags. I updated my Operator and BMPFlags from Active Display last night but something didn't quite work out right there! BS is now opening and closing ok and I can access "Display Settings" ok.

Thanks for your help, at least I'll know what to do if I have the same problem again.

Peter

[Anmer]

Good to know all is well again.