Raspberry 3 Pi and FlightAware Pro Plus

[goingaround]

In PP what do you have set for:

Options-> I/O Settings-> Mode-S/ADS-B->

Options-> Mode-S Receiver->

For the Mode-S/ADS-B > i have tried Beast and RTL>RPi+Dump1090
I have used Beast for the Mode-S Receiver with TCP/IP client as 127.0.0.1:30009
Putting Beast in the I/O settings crashes PP

[goingaround]

I am appreciative of the replies and suggestions I have received.
I am starting to think that maybe my PP software that hadn't been used for a while has become corrupted and I am thinking of removing it completely from the PC and reinstalling it, and then revalidating. I realise that after a while of not being used a different share code is issued which I have noted, and when I corresponded to PP I actually received another share code.
I don't understand the workings of PP well enough to know whether that could make a difference.
The other area that I have wondered about is could my Raspberry have permissions set refusing modesmixer from copying the data? Once I would appreciate any comments.

[Anmer]

I don't have your setup so can't test anything.  But a different PP Share Code shouldn't make a difference.

For PP I/O which Beast are you selecting?  Serial or TCP?

[goingaround]

The TCP option

[Anmer]

Thanks.

Maybe IanH will see this post again and offer some help.

[goingaround]

OK, thanks Mike.

[goingaround]

OK I have finally achieved inputting my data to PlanePlotter.

Info for reference to others may follow:-

Input/Output

Modes/ADSB
RTL>RPi+dump1090
AutoMilat
UDD/IP from net
9742

ModeS Receiver
RTL Dongle RPi Dump1090
and my rasberry IP appended with:30005
(all items shown selected)