Data settings & Time outs

[Pipo]

Since this year i have a outside antenne on 32feet, and get a good reading on planes (even those flying above Paris), now i was looking inside basestation and i see there is a "time-out" option in Data settings:

mine are set like this:
Position lost: 30
Signal lost: 5
Remove: 300
Delete: 1800

Message filtering: all are not selected.

Do i need to leave this like it is or any1 have tips to set this up?

[s92driver]

Your settings will result in aircraft that are no longer being picked up by the receiver still being displayed for 300 seconds.  I have the following settings so that pretty much only active aircraft are shown:

Position lost:  10
Signal lost:  20
Remove:  20
Delete:  300

There's no right or wrong, it's down to personal choice.  However if you're capable of picking up lots of aircraft simultaneously then perhaps having "Lost" aircraft removed in a shorter time might be something worth considering?



Steve

[Pipo]

Your settings will result in aircraft that are no longer being picked up by the receiver still being displayed for 300 seconds.  I have the following settings so that pretty much only active aircraft are shown:

Position lost:  10
Signal lost:  20
Remove:  20
Delete:  300

There's no right or wrong, it's down to personal choice.  However if you're capable of picking up lots of aircraft simultaneously then perhaps having "Lost" aircraft removed in a shorter time might be something worth considering?



Steve

Going to give it a try, if i want to go back i can always put my info. Thanks for your reply

[Anmer]

Your Remove and Delete are too long in my view.

As s92driver has suggested, make them shorter.

Mine are:

Remove: 30
Delete: 300

Or experiment.  Nothing is lost.