Radarspotting

Mode-S Receivers => DVB-T Dongles and Self-Assembly Receivers => Topic started by: motokops on February 17, 2021, 09:13:34 AM

Title: LNA + filter installation
Post by: motokops on February 17, 2021, 09:13:34 AM
I have this band pass filter and this amplifier LNA. What would be the correct and most effective order of placement respecting IN and OUT?


Antenna --- xxxxx  ----   xxxxx ----- USB RTL SDR receptor

Thanks.

[attachment deleted reduce file load]
Title: Re: LNA + filter installation
Post by: Anmer on February 17, 2021, 09:22:54 AM
Is it powered?
Title: Re: LNA + filter installation
Post by: motokops on February 17, 2021, 09:35:39 AM
Yes, of course.

All OK. Working perfectly. I just want to know the correct order so that it works fine. IN/OUT

Title: Re: LNA + filter installation
Post by: Anmer on February 17, 2021, 09:45:18 AM
Maybe:

Antenna - Filter - Amplifier - Receiver

No point amplifying data you don't need?
Title: Re: LNA + filter installation
Post by: motokops on February 17, 2021, 09:59:30 AM
is a good logical answer

Thanks
Title: Re: LNA + filter installation
Post by: abcd567 on February 23, 2021, 12:38:46 AM
Quote from: Anmer on February 17, 2021, 09:45:18 AM
Maybe:

Antenna - Filter - Amplifier - Receiver

No point amplifying data you don't need?

Fully Agree.

Just to see the difference, run an RF scan covering full frequency range of the dongle (24 Mhz to 1800 Mhz) in both the orders i.e.
Antenna>Filter>Anplifier>Dongle
Abtenna>Amplifier>Filter>Dongle

NOTE: This scan is pretty fast. One sweep across 24 Mhz to 1800 Mhz takes about 3 to 5 minutes. Few sweeps are enough

Do I Need A Filter - OPTION-4 (https://radarspotting.com/forum/index.php?topic=9620.msg53022#msg53022)



Title: Re: LNA + filter installation
Post by: motokops on March 01, 2021, 12:58:26 AM
I have done the test   Antenna - Filter - Amplifier - Receiver

The filter and amplifier works very well.

In the attached file the result

Thanks.







[attachment deleted reduce file load]