Print Page - SBS 3 default settings

Title: SBS 3 default settings
Post by: aviaction on September 30, 2015, 05:02:43 PM

Is there a way to reset the SBS3 so it is at default factory settings, as supplied new?

Title: Re: SBS 3 default settings
Post by: Anmer on September 30, 2015, 05:35:49 PM

Do you mean the SBS-3 receiver or BaseStation software?

Title: Re: SBS 3 default settings
Post by: aviaction on September 30, 2015, 07:15:07 PM

I mean the receiver itself.
Does it not store changes to IP address etc.??

Title: Re: SBS 3 default settings
Post by: Triple7 on September 30, 2015, 07:41:40 PM

Sounds like you might need the EM Utility - Anmer is your man for that.

I needed to reset the IP address of my SBS1eR (2nd hand) to the default 192.168.1.170 and it worked perfectly.

Tim

Title: Re: SBS 3 default settings
Post by: Anmer on September 30, 2015, 08:35:54 PM

Quote from: aviaction on September 30, 2015, 07:15:07 PM
I mean the receiver itself.
Does it not store changes to IP address etc.??

How are you changing the IP address? Check page 93 of the Reference Manual.

If the address is different to your LAN range, you can connect using USB cable and then change the address.

Title: Re: SBS 3 default settings
Post by: aviaction on October 03, 2015, 09:36:20 AM

Thanks again.
SBS3 already gone to new (happy)owner, but does live nearby if any issues arise.

Stef

Radarspotting

Mode-S Receivers => Kinetic's SBS-3 => Topic started by: aviaction on September 30, 2015, 05:02:43 PM